Resin x Marbelux Calculator

Welcome to our resin & marbelux calcuator! Here you can workout how much you need of each. Depending on what you are making there's a few ways to go about it.

Firstly, the amount of resin required is the volume of the mould or pour that you are going to do. For cuboids, this is easy to work and you can use our calculator below.

For coating a piece you can also use our calculator below, we recommend setting the depth as 2mm. Depending on how warm the resin is it might be slightly thicker or thinner than this.

For moulds the best option is to fill it with water. The amount of water needed to fill the mould is how much resin you will require. However, ensure you dry the mould before filling it with resin, as water will react badly with our resin. We also recommend having roughly 10% more than you think you require, just in case your calculations are slightly out or there is any wastage.

If working out how much marbelux to use in a mould, use our 2nd calculator down below!

Resin & Marbelux

Enter your project dimensions below to find out exactly how much resin or Marbelux you need. Using a mould? Check out our mould calculator further down the page.

Dimensions
Results
cm
cm
mm
Your Results
Total Resin Required Original / Deep Pour / UV
0.00L
💡
Total Marbelux Required
0.00kg
Casting Powder (¾ of total)
0.00kg
Liquid (¼ of total)
0.00kg

We recommend adding 5–10% extra to account for waste and overpour.

Marbelux Mould Calculator

Working with a silicone mould? If it is one of ours you should be able to find the resin amount needed on the product page. But if you are not using one of our moulds, all you need to do is measure how much water it takes. The amount of water is the same amount of resin!

P.S. Make sure your mould is totally dry before you pour resin into it!

If you are working with Marbelux, simply find out the amount of water it takes and then type it in below to get your Marbelux measurements.

Results
ml
Your Results
Total Resin Required Original / Deep Pour / UV
0.00ml
Total Marbelux Required
0.00g
Casting Powder (¾ of total)
0.00g
Liquid (¼ of total)
0.00g

We recommend adding 5–10% extra to account for waste and overpour.